Fitting the Lowers

Fitting the Lower Registers this past week was more than a bit challenging. The challenge presented itself when I discovered that the pinblock supports were too short.This is the original maple block, coming up 1/2″ short. The lower register needs to fit perfectly between the dado in the rail (on the right) and there is a hole on the bottom side of the notch that accepts a screw to secure and allow adjustment of the register.

OLYMPUS DIGITAL CAMERA

Fortunately they had (have) not been glued in yet, so they were removed and rebuilt to the exact size required after checking the plans at least ‘twice’. Mistakes happen! As it turns out, when I reviewed what went wrong I had taken the overall length from the bottom of the block where the ‘notch’ is cut instead of the top. So, this gave me a chance to make the blocks out of oak, same species as the pinblock itself. Here is the new block showing how the lower register fits snugly into the notch. The original plan called for a 6 x 3/4″ screw to secure the register, but it is in a very difficult place to use a screwdriver to put the screw into place, so I removed the blocks and tapped the holes with a 10×24 tap (which just basically threads the wood for a machine type screw). This solution makes it much easier to insert the screw once you put the register into place. This photo also shows more clearly how the register fits into the dado in the belly rail.

Harpsichord_253_Knurled_screw_right_sm

Tapping the pre-drilled hole was quite simple. Here you can see the tapped hole with a screw inserted on the right. On the left is a freshly tapped hole and below is a knurled screw that accepts an allen wrench (shown) and the tap itself is at the bottom of the photo. It is very important that the tap and the screw are the exact same thread size.

Harpsichord_248_Tapping_New_Pinblock_small

And finally here is what the lower register looks like installed.

Harpsichord_242_Fitting_Lower_Register_small

About npcarey

Amateur Luthier, woodworker, music enthusiast, software enthusiast
This entry was posted in Harpsichord and tagged . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s